Skip to content

Serving all 50 states + Washington, DC

Keystream Plumbing logoKeystreamPlumbing

Water heaters

Water Heater Pilot Light Won't Stay Lit: Causes and Fixes

Updated · By the Keystream Plumbing editorial team · How we research

Short answer: When a pilot lights but goes out as soon as you let go of the knob, the thermocouple is usually worn or out of the flame. A pilot that goes out on its own after hours or days points to a dirty pilot tube, a draft, a kinked gas line or, on newer heaters, a flammable vapor sensor that has tripped. Thermocouple replacement is a common, quick repair.
Close-up of a water heater pilot tube and thermocouple above the burner

How the pilot stays lit

On standing-pilot gas water heaters, a thermocouple sits in the pilot flame. Heat makes it produce a tiny electric signal that holds the gas valve open. If the thermocouple is weak, bent away from the flame or dirty, the valve closes and the pilot goes out. That is a safety feature: it stops gas flowing when there is no flame.

The common causes

  • Worn thermocouple: lights fine but goes out when you release the knob
  • Dirty or partly blocked pilot orifice: small, weak or yellow pilot flame
  • Draft from a door, window, fan or vent blowing the flame out
  • Flammable vapor sensor tripped: newer heaters lock out if they sense fumes or if lint and dust block the air intake screen at the bottom
  • Gas control valve failing: the pilot will not stay lit even with a new thermocouple

What you can safely check

Follow the lighting instructions on the label on the heater exactly. Look at the pilot flame: it should be steady and mostly blue, wrapping the tip of the thermocouple. Check for drafts and clean any dust and lint from around the base. If there is a flashing status light, count the flashes; the label or manual lists what they mean.

If you smell gas at any point, stop, leave and call the gas utility.

When to call a plumber

Call when the pilot will not stay lit after following the lighting steps, when the flame is yellow or lifting, when a status light shows a fault, or when you are not comfortable working near the burner. A plumber replaces the thermocouple or pilot assembly, cleans the pilot, and checks the gas valve and venting. See water heater repair.

Frequently asked questions

How long does a thermocouple last?

Often several years, but heat, dirt and age wear it out. It is a low-cost part and usually the first thing replaced when a pilot will not stay lit.

Can wind blow out a water heater pilot?

Yes. Strong drafts from doors, vents or a back-drafting chimney can blow it out. A heater in a garage is more exposed.

Is it worth fixing the pilot on an old water heater?

A thermocouple or pilot repair is usually worth it. If the tank is near the end of its life, typically 10 to 15 years, and other parts are failing, replacement may make more sense.

Editorial note: This guide is general information for homeowners, not a substitute for an on-site assessment. Local codes and conditions vary; a licensed pro can confirm what applies to your home. See our editorial policy.

Rather have a pro handle it?

Call (833) 520-4758.

Call now(833) 520-4758