Skip to content

Serving all 50 states + Washington, DC

Keystream Plumbing logoKeystreamPlumbing

Water heaters

How to Flush a Water Heater

Updated · By the Keystream Plumbing editorial team · How we research

Short answer: Turn off the power (electric) or set the gas to pilot, close the cold supply valve, connect a garden hose to the drain valve and run it to a floor drain or outside, open a hot faucet, and drain the tank. Briefly open the cold supply to stir and flush until the water runs clear, then close the drain, refill the tank completely and only then turn the heat back on.
Illustrative clip: a hose connected to a water heater's drain valve and run to a floor drain.
Garden hose connected to a water heater drain valve, running to a floor drain

Why flush it

Sediment collects at the bottom of a tank, making it noisy, less efficient and quicker to wear out. Many manufacturers recommend flushing once a year, and more often in hard water areas.

Before you start

The water inside is hot enough to scald. Let it cool for a few hours if you can, or run hot water first. Check the drain valve: plastic valves on older heaters can break when opened. If yours is old, cracked or dripping, a plumber can replace it with a brass ball valve.

Step by step

  • Electric: turn off the breaker. Gas: set the control to Pilot or Vacation
  • Close the cold water supply valve on the pipe above the heater
  • Attach a garden hose to the drain valve and run it to a floor drain or outside, lower than the valve
  • Open a hot water faucet somewhere in the house so air can enter
  • Open the drain valve and let the tank drain
  • Open the cold supply for a few seconds at a time to stir up sediment, and repeat until the water runs clear
  • Close the drain valve, remove the hose and open the cold supply fully
  • Leave the hot faucet open until water flows steadily with no air, which means the tank is full
  • Turn the power or gas back on

Do not turn the heat on with an empty tank

On an electric heater, powering the elements when they are not under water burns them out in seconds. Always refill completely first.

When to call a plumber

Call if the drain valve will not open or will not close, if the water never runs clear, if you find a leak from the tank itself, or if the heater does not heat afterward. Tankless heaters are flushed differently, by circulating a descaling solution, and need service valves. See water heater repair.

Frequently asked questions

How often should I flush my water heater?

Many manufacturers recommend once a year. Very hard water may call for more often; soft water can stretch it. Check your heater's manual.

Should I flush a water heater that has never been flushed?

Often yes, but on an old tank with heavy sediment, flushing can clog the drain valve or, rarely, expose a leak the sediment was sealing. A plumber can judge whether it is worth it.

How long does it take to flush a water heater?

Usually about an hour, most of it draining and refilling.

Sources

Editorial note: This guide is general information for homeowners, not a substitute for an on-site assessment. Local codes and conditions vary; a licensed pro can confirm what applies to your home. See our editorial policy.

Rather have a pro handle it?

Call (833) 520-4758.

Call now(833) 520-4758